7. Motor Plate Fixing
.JPG)
The motor plate is placed on the casing
.JPG)
The plate is placed at 160mm as per worksheet{C100-160}
.JPG)
It is clamped using the C-clamp
.JPG)
2 clamps and an even stopper are used to set the plate in rigid position
.JPG)
Then the plate is welded
.JPG)
.JPG)
Then the "leg" of the plate is placed
.JPG)
2 legs to support the motor plate
.JPG)
Both are welded
.JPG)
.JPG)
The length between both are measured
.JPG)
.JPG)
After the motor plate and 2 legs are welded
.JPG)
.JPG)
Completed and ready for the cutting of inspection door
No comments:
Post a Comment